Categories

Changing the drive belt on 18" Echelon Electric Snow Blower

Last Modified: 02/04/2015

This should only take about 15 minutes and all you need is a phillips screw driver and a 10mm wrench/socket

Be sure to unplug the snow blower before attempting this!

Start by removing the two bolts on the back of the machine...

now the upper two screws on each side in the red part of the housing...

and the bottom 2 on the drive side...

2 screws on either side of the discharge chute...

Now tip the unit on its back and you will see 4 screws to remove...

Now you can remove the discharge chute...

Now you can lift the red hood off the base.  Be careful as there are wires attached to the reset switch.  Now is a good time to check the reset switch wires to make sure they are firmly attached.  If the connectors are loose you can squeeze them with pliers to make a tighter fit.

Here is the correct route for the belt...

It is easier to take on or off when the belt is off the tensioner pulley...

Once the belt is installed you can re-assemble the unit in the reverse order of these instructions.

 

 

 

 

Was this article helpful? (1-Lowest, 10-Highest)
Comments:
Subtotal: $0.00

About Us | Contact Us | Privacy Policy | Shipping and Returns | Terms and Conditions